Welcome to Wholesale LED Strip Online store

Welcome! Sign in or Register

See All Categories

LED Light Controller

Johnson is Online to help you.

Home > Wholesale LED Light Controller

other item in the list

View Larger Image

RGB Controller with KeyMatch RF Touch Color Remote

item#: LSH-C17E-E17

Retail price: 0

Wholesale Price:

US$ € £ CA$ AU$ HK$ CHF

43.99

Start from: 1 Unit(s)

Qty.Range(unit)	Price(per unit)	Discount
Large Order:

0+ Shipping Cost

Quantity:

Product Details

Specification:

RGB Controller with KeyMatch RF Touch Color Remote Installation

RGB Controller with KeyMatch RF Touch Color Remote is used to control 12 Volt RGB LED Light Bars and Light Strips with common anode wiring, such as our xFLS-RGB series Light Strip. Using the included hand held wireless Touch Color remote controller for direct accessability to all modes, RGB Light Strips can be set to one of 24 different static colors or one of 15 different dynamic color changing patterns. The remote control can also adjust pattern speed, brightness, and turn system ON and OFF. With 18 Amp continuous load capability at 12 Volts, RGB Controller with KeyMatch RF Touch Color Remote can drive up to 48 meters of our xFLS-RGB Light Strips. For longer runs use our RGB Amplifiers.

Technical Parameters

Applications:	Direct access color selection and functions with dimmable and speed controls
Function:	Control 3 channel RGB LED products using wireless RF remote
Operating Voltage:	12 VDC – match power supply voltage to RGB LED product voltage
Connection Mode:	Common Anode (+)
Output:	Three CMOS drain-open output
Maximum Load Current:	12VDC – 6 Amps per channel (18 Amps total) 24VDC - 6 Amps per channel (18 Amps total)
Output Power:	216 Watts
Control Method:	Wireless RF Remote Control - Frequency 433MHz
Batteries Required:	Three AAA batteries
Modes:	39 Total (24 static single color and 15 dynamic color changing)
Operating Temperature:	-25~60°C

SIMPLE INSTALLATION:

Multi-Reciever Programming

RGB Controller with KeyMatch RF Touch Color Remote features transmitter to receiver keying to help eliminate interference from other nearby units. If you wish to control several receivers from a single transmitter, the receivers first must be re-programmed. The easiest and fastest way to re-program several receivers at once is to have them share a power supply or all plug in to a single power strip (Once programmed you can provide power as you would otherwise, sharing is only needed for the programming phase to ease the process -- Re-programming can be done one device at a time also).

Controller Connections

Programming Procedure:

Wire all receivers to one power supply or power strip but don't turn it on yet.
With the power off, grab the remote.
Turn on the power supply.
Within 3 seconds of providing power press the button once.

If programming was successful any connected light strings should blink three times.

NOTES:

1.) Do not scratch the sensing area. Do not disassemble, repair, or modify the device.
2.) Disconnect the power (adapter) before installing/removing this controller.
3.) Do not use this device near water, or moisture for indoor use only.
4.) This product should only be operated from the type of power source indicated on the label.
5.) When mutliple receivers share one remote, it's possible for the patterns to visually drift apart over time. The single color modes are unaffected and remain synced.

RF Touch Color Remote Control

Typical Wiring Schematic

Print Page

Write a Review:

Tell us what you think about RGB Controller with KeyMatch RF Touch Color Remote, share your opinion with other people. Please make sure that your review focus on RGB Controller with KeyMatch RF Touch Color Remote. All the reviews are moderated and will be reviewed within two business days. Inappropriate reviews will not be posted.

Have any question or inquire for RGB Controller with KeyMatch RF Touch Color Remote? Please contact Customer Service. (Our customer representative will get back shortly.)