DMX LED Color Decoder

With LEDstriphome DMX LED Color decoder you will be able to fully control our LED strips from your centralized DMX console (the decoder converts DMX-512 control signals to PWM controller signals for driving our Tri-Core Strips).

With this DMX decoder you will be able to control up to 16ft / 5m (1 reel) of our Tri-core LED strips. You can expand the reach of the decoder by using a signal amplifier.

Technical Parameters

SIMPLE INSTALLATION:

LEDstriphome DMX Decoder is connected to the DMX digital console through a standard DMX connector and easily connected through terminal blocks or similar to our RGB Tri-Core LEDstriphome strip. With this fantastic accessory you will be able to fully control our RGB strips from your centralized DMX console (the decoder converts DMX-512 control signals to PWM controller signals for driving our Tri-Core Strips).  To set the address code of the module (from 1 to 1022) you can use the DMX editor of your DMX system.

VERSATILITY:

Our controller work with any 12V DC RGB fixture with common anode and 4 channels, so you will be able to control not only our Tri-Core strips but other supporting fixtures in your installation.

BUILT-IN FUNCTION:

In the absence of receiving a DMX signal, our DMX LED Color decoder will act as a controller thanks to a built-in function that will set a multicolor gradual change in our strips.

WIRING DIAGRAM:

SETTING UP:

1. Connect signal wire first, then load wire and last connect the power wire. Please make sure that short circuit cannot occur between the wires before turning on the power.
2. In the absence of receiving DMX signal, our DMX01 decoder will act as a controller thanks to a built-in function that will set a multicolor gradual change in our strips.
3. Receiving DMX signal, the built-in function will not be available and the system will be controlled completely by DMX computer console.
4. To set the address code of module ( from 1 to 1022) use DMX editor of your DMX universe.
   

DIMENSIONS: